DIY Possible - Licensed Plumber Recommended

Faucet Installation or Replacement Cost in Des Moines, IA

Cast Iron – 2 Bath (Pre-1960)

The average cost of faucet installation or replacement in Des Moines, IA with Cast Iron pipes (2-bath, 1,500 sq ft) is $630, with most homeowners paying between $520 and $770 depending on access difficulty, permit requirements, and contractor availability.

Cost Breakdown - Des Moines, IA

Parts & Materials
$290
Cast Iron profile
Labor
$300
2.6 hrs x $100/hr
Permits & Misc
$40
permits, disposal, parts
Total Estimate
$630
Range: $520-$770

* Estimates based on Des Moines area labor rates ($100/hr). Actual costs vary. Get 3 quotes.

Home Profile

Pipe Material
Cast Iron
Bathrooms
2 Bath
Home Size
1,500 sq ft
Local Labor Rate
$100/hr

Signs You Need This Service

  • !Constant dripping even when fully off
  • !Corroded or stiff handles
  • !Low water pressure from one faucet only
  • !Outdated fixture during renovation
  • !Leaking around base or under sink

What is Included

  • +Shut off supply valves
  • +Disconnect and remove old faucet
  • +Install new faucet per manufacturer specs
  • +Connect hot and cold supply lines
  • +Test operation and inspect all connections

DIY Potential

This job is DIY-viable for homeowners with basic plumbing skills. Check local permit requirements first.

Shop kitchen faucet single handle pull down sprayer on Amazon

Ready to Hire a Plumber in Des Moines?

Use this estimate as your baseline. Get at least 3 quotes and ask each plumber to itemize parts, labor, and permits separately.

Fair range: $520 to $770

Compare Quotes from Top-Rated Plumbers via Angi

Frequently Asked Questions

How much does faucet installation or replacement cost in Des Moines, IA?

The average cost of faucet installation or replacement in Des Moines, IA is $630, with most homeowners paying between $520 and $770 depending on home conditions and contractor availability.

How long does faucet installation or replacement take?

Most faucet installation or replacement jobs take 2.6 hours for a 2-bathroom home with Cast Iron pipes. Complex jobs or older homes may require additional time.

Can I do faucet installation or replacement myself?

This is a DIY-viable job for homeowners with basic plumbing skills. However, always check local permit requirements first.

What affects faucet installation or replacement cost in Des Moines?

Key cost factors include pipe material (Cast Iron), home size (1,500 sq ft, 2 baths), local labor rates ($100/hr in Des Moines), and permit fees.

Explore Related Pages

-> Water Heater Replacement (Tank) for this home profile-> Same service in Cedar Rapids, IA-> Same service in New York, NY-> Same service in Los Angeles, CA

Affiliate disclosure: Plumbing Repair IQ participates in the Amazon Associates program. Shop related products